Versa-Ball Pedestal Mount NOW! Mounting your downrigger board is easy. -No More Washers -No More Shims! -EASY ON AND EASY OFF! Bottom section tilts and locks in any position up to 30 degrees to match the contour of your boat and still be flat on top. Size: 3" Wide 5 1/2 Long 6 1/2 High 2 Complete units per box. Eagle Feet Downrigger deck mounting brackets. Easy On, Easy Off - No unsightly holes in your boat. Fasten Eagle Feet to plank and clamp assembly to outside bumper rail of boat. 2 per box, 1 for each side of boat Ball Babies Don't lose control of your downrigger weights while changing baits! No more slamming against the boat, rolling on the floor, or getting greasy in the motor well. Ball Babies retainers will hold your weights in place ready for your next use. 2 units per box. Trol-A-Matic Troll or Speed w/ Trol-A-Matic on your inboard-outboard or outboard. Inexpensive Lightweight Easy to Install Trol-A-Matic is ideal for all kinds of fishing under all types of conditions. Constructed of fiberglass filled nylon to eliminate corrosion and rust. Once installed, skipper has complete range of speeds from which to choose, from very slow, ideal trolling speed to wide open throttle with no interference whatsoever! This revolutionary trolling device is completely automatic and swings up as speed is increased. Hook Stick Never crawl on your trailer and risk injury again thanks to the Hook Stick! Simply slide the winch hook into the tapered grove, and stand safely on the dock, while inserting the winch hook into the eye, on the front of your boat. Ultra-Mount The Ultimate Device for Mounting Electronics Ultra-Mount II Swivels 360 degrees in 10 degree increments. Top Plate 3" x 6" Total Height 1 1/4" Easy On Easy Off!!! Ultra-Mount III Swivels 360 degrees in 10 degree increments. Top Plate 3" x 6" Total Height 2 3/4" Tilts (to keep units level) Also can be used for overhead mountings Easy On Easy Off!!!! Trac -N- Turn TNT #1 Rod Holder Only (for use in an aluminum rail or snap base TNT #2 32" Trac with 3 Rod Holders. TNT #2.1 32" Trac with 3 Rod Holders. 2 Pedestals and 2 Snap Out Bases. TNT #5 Combined Trac n Turn #1 and Snap Base TNT #6 Snap Base with 15" Trac and 2 Rod Holders TNT #7 96" Aluminum Trac, 2 Pedestals, 2 Snap Bases, End Caps w/ 4 Rod Holders TNT #8.1 96" Downrigger Deck, All Extruded Aluminum w/ Nylon End Caps. Also includes 1 set of Versa-Ball Mount. TNT #8.2 32" Downrigger Deck, All Extruded Aluminum w/ Nylon End Caps. Also includes 1 set of Versa-Ball Mount.